[ad_1]
My previous setup was operating a reasonably huge 360-mm AIO CPU cooler, which could be overkill, however it did elevate an attention-grabbing predicament when transferring into the X50. Ideally, the radiator can be mounted on the high of the case, so the pump within the CPU block is at all times stuffed with liquid, however with the PSU on the high, that’s not an possibility.
Fortunately, each the entrance and motherboard sides of the case assist as much as three followers every, with room for large radiators. There are sufficient choices that I truly spent fairly a little bit of time agonizing over how I wished to configure my followers. I ended up mounting my big cooler on the aspect of the case and put in three followers within the backside for consumption, which isn’t my favourite setup as a canine proprietor, however the magnetic filter has been straightforward sufficient to maintain clear. My GPU immediately advantages from the cool air consumption on the backside, and my CPU radiator has been operating round six levels cooler than it was earlier than.
In the case of truly constructing within the system, there’s a stunning quantity of area each within the entrance of the case and behind the motherboard. A tough drive bay takes up a big chunk of room, however like most folk, I’m solely utilizing M.2 drives at this level, so I went forward and eliminated it to make room for my fan and pump controller. There are a couple of spots that get just a little tight, just like the cable attic subsequent to the facility provide, and the area down on the backside the place the IO cables cross underneath the motherboard, however they shouldn’t be a difficulty when you’re achieved constructing, and there are many tie down factors with hook and loop straps all through to maintain issues organized.
The Quest for Perfection
{Photograph}: Brad Bourque
When a case appears to be like this trendy, it may be onerous to stay as much as that splendid, which is my essential criticism concerning the X50. As I put the ending touches on my construct, I couldn’t assist however discover all of the little particulars I hadn’t been in a position to account for. The fan cables, for instance, had been bundled up properly however had been clearly seen within the hole beneath the motherboard. In the meantime, my energy provide fan met one finish of the round cutout however left a noticeable hole on the far finish, with seen cables between. Neither has any impact on efficiency, however I discover them each time I examine the system.
[ad_2]
